Services

Support for teams that need senior‑level electronics and embedded engineering without committing to a full‑time hire.

Electronics Design

Architecture and partitioning
Schematic capture
PCB design, layout guidance and review
Power, sensing, and connectivity

Embedded Firmware

Board bring‑up and low‑level drivers
Application‑level logic and state machines
Debugging and performance tuning
Prototyping and proof‑of‑concepts

System & Product Support

Design reviews and risk identification
DFM/DFT considerations
Vendor and CM technical coordination
Support for documentation and test planning

Engagement styles

Project‑based work

Well‑scoped efforts with defined deliverables, such as a prototype design, a board revision, or a focused firmware feature set.

Ongoing support

Part‑time, ongoing involvement where I act as a senior engineer you can rely on for design work, reviews, and technical decision support.

Lab Capabilities

Tools and equipment that support rapid prototyping, board bring‑up, and detailed electrical evaluation.

Signal measurement and analysis using a mixed‑signal oscilloscope, current probing, and vector network analysis for RF and EMI investigation.
Electrical characterization with multiple digital multimeters and a regulated bench power supplies for controlled power‑up, fault testing, and measurement accuracy.
Thermal evaluation using infrared imaging to identify hotspots, verify thermal paths, and assess component stress.
Prototyping and rework with soldering, hot‑air, and hot‑plate tools for assembly, modification, and repair of prototype hardware.
Stimulus and verification using signal generation for functional testing and evaluation.
Custom test setups and fixtures to support repeatable measurements, device evaluation, and system‑level testing.

If your project requires additional mechanical, industrial design, or broader team capacity, I collaborate with trusted partners such as 5 Design & Development to scale appropriately while keeping a single technical point of contact.